Draw-Tite 59110 ADVENTURE SYSTEM - Manual (Page 3)

Product Code:
Product Name:
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
www.rolaproducts.com
(T258) 112816 10-18-05 Rev A
Adventure System
59109 / 59110
Attach the support brackets to the Swing-Away MAIN SUPPORT assembly. Install the 3/8” x 1.25” hex bolts, flat
washers, lock washers and hex nuts through the holes in support bracket and into the holes in plates on the
MAIN SUPPORT assembly. Repeat for other support bracket. NOTE: Attach support brackets with the flanges
to the inside as shown.
Tighten 3/8” hex bolts to 30 ft-lb.
SUPPORT BRACKET
BRACKET FLANGES TOWARD
THE INSIDE AS SHOWN
3/8” x 1.25 CAP SCREW
3/8” FLAT WASHER
3/8” LOCK NUT
5/8” PIN
SPRING CLIP
FLAT WASHER IS
SANDWICHED BETWEEN
THE SUPPORT BRACKET
AND HINGE PLATE
HOLE FOR BAIL
LOCK PIN
Attach the support brackets to the Tilt-Up MAIN SUPPORT assembly. Install the 3/8” x 1.25” cap screw through
the INNER hole in bracket with the flat washer placed between the bracket and the hinge plate on MAIN
SUPPORT assembly. Install 3/8” lock nut on cap screw and tighten until snug. Repeat for other support bracket.
NOTE: Attach support brackets with the flanges to the inside as shown. 3A
MAIN SUPPORT
ASSEMBLY
Tilt-Up Model
INNER HOLE TO
ATTACH BRACKET
HINGE PLATE
Please read all instructions carefully before assembly, installation and/or use of this product.
Page 3 of 27
3/8” x 1.25 HEX BOLT
3/8” FLAT WASHER
3/8” LOCK WASHER
3/8” LOCK NUT
BOTH SIDES
Swing-Away Model
3B
MAIN SUPPORT
ASSEMBLY
SUPPORT
BRACKET
BRACKET FLANGES TOWARD
THE INSIDE AS SHOWN
SPRING CLIP
5/8” PIN