Draw-Tite 6501 CARGO CARRIER - ADJUSTABLE User Manual
Item: description, Hitch mounted cargo carrier

ITEM:
DESCRIPTION:
Cequent Performance Products - Plymouth, MI
Technical Service: (888) 521-0510
6554 Rev C 10-6-09
Printed in XXXXX
6500 / 6501
HITCH MOUNTED CARGO CARRIER
TOOLS REQUIRED:
9/16 Wrench
CONSUMER: Keep instructions and read before each use.
Tie down holes
Reflector
Cargo Platform
License plate relocation holes
(FOR DAYLIGHT USE ONLY)
500 LB.
300 LB.
MFR'S TONGUE WEIGHT RATING OR
DO NOT EXCEED LOWER OF VEHICLE
CARGO CARRIER
6500 (20" X 48")
6501 (20" X 60")
HITCH TONGUE WEIGHT RATING OR
RATING
APPROVED FOR USE WITH
Cequent Towing Products
FIGURE 1.
Pin & Clip
(sold separately)
Shank Assembly
3/8-16 x 3.00 GR5
Carriage Bolt
Hex Locknut
(2) Places
CARGO CARRIER ASSEMBLY:
1.
Place shank assembly in receiver hitch on vehicle and install pin & clip.
2.
Place cargo platform on shank assembly and adjust cargo platform for proper clearance from vehicle bumper –
minimum 1” to maximum 4” clearance). NOTE: Cargo platform can be rotated 180 degrees for further adjustment.
3.
Install shank assembly fasteners as shown in figure 1 and tighten to 20 LB-FT.
4.
Apply reflectors to rear corners of cargo platform as shown in figure 1.
5.
Attach clip to reminder card.
DASHBOARD REMINDER
During use attach the reminder card in a visible
location near the driver (for example: a heating/cooling vent).
DO NOT attach to rear view mirror or where it will obscure the
view of the road.
REMINDER
CARGO CARRIER IN USE
CHECK REAR
CLEARANCE