beautypg.com

Draw-Tite 118271 OEM WIRING HARNESS User Manual

Ef d, English

background image

WARNING

Route the wire being careful to avoid any hot

pipes, heat shields, the fuel tank or any other

points that may pinch or break the wire.

WARNING

All connections must be complete for the

T-Connector to function properly. Test and

verify installation with a test light or trailer

once installed. For initial test, reset vehicle

electrical system by temporarily removing

the key from the ignition.

WARNING

Overloading circuit can cause fires. DO NOT

exceed lower of vehicle manufacturer rating or:

• Max. stop/turn light: (10 amps)

• Max. tail lights: (10 amps)

• Max. backup: (10 amps)

• Max. power circuit: (20 amps)

• Max. trailer brakes: 3 Axles/

6 brakes (18 amps)

Read vehicle’s owners manual &

instruction sheet for additional information.

ENGLISH

TOOLS REQUIRED:

Test-probe

1. Under vehicle hood, locate the vehicle’s

fuse box

d

. Insert relays and fuses into

positions shown

e

.

Insert 10 Amp Fuses (Provided) in the

following locations:

Trailer Park Lamp, Position F41

Left Turn Trailer Stop/Turn, Position F21

Right Turn Trailer Stop/Turn, Position F17

Trailer Back Up, Position F8

Insert 30 Amp Fuses (Provided) in the

following locations:

Trailer Brake, Position F34

Trailer Power, Position F30

Insert relays. (included)

NOTE

The use of relays that differ from the relays

included can result in the unit not to function

or may damage the vehicle and or trailer.

Insert Relays (Provided) in the

following locations:

Right Turn Trailer Stop/Turn, Position R16

Left Turn Trailer Stop/Turn, Position R15

2. Locate the vehicle’s towplug located under

the vehicle on the passenger side. Locate

the opening to the right of the vehicle muffler.

Reach up into opening to locate the vehicle’s

grey towplug

f

. Disconnect the mating

protective cover and discard. Connect the

towplug harness into mating harness. Check

to see that the mating surfaces of the wiring

connectors match. All connector surfaces

should be clean and free of dirt. Be careful

not to damage the locking tabs and be sure

that connectors are fully inserted with

locking tabs in place.

3. Plug the 7-way socket (provided) into the

Trailer Tow Harness. Route 7-Way to the

center of vehicle. Mount the 7-Way end in an

accessible location with a bracket or electrical

box (not included). Secure the remainder of

the T-connector harness with the cable ties

provided, to prevent damage or rattling and

being careful to avoid any areas that would

cut or pinch the wire.

Installation Instructions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

118271-037

Rev. A

2/5/14

READ THIS FIRST:

Read and follow all vehicle warnings and installation

instructions before beginning installation. Wear safety

glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:

Lire et observer toutes les consignes de sécurité et les

instructions avant de commencer l’installation. Durant

l’installation, veiller à toujours porter des lunettes de

protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:

Lea y siga todas las advertencias e instrucciones de

instalación del vehículo antes de empezar la instalación.

Use gafas de seguridad y todas las precauciones de

seguridad durante la instalación.

PAGE 1 OF 3

e

f

d

Chevrolet

Traverse

GMC Acadia

Buick Enclave