Draw-Tite 20269 WIRING ADAPTER - Manual

18269-037 Rev. A 03/21/07
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover
1. Carefully remove vehicle trim panel
underneath dash making sure not to pull
on courtesy lamp wires that are attached
d.
2. Locate the vehicle’s electric brake control
harness connector e. The harness will be
located underneath the dash and left of the
steering column, taped to another harness
near the emergency brake pedal. There will
be a 6-pin connector that mates with the one
on the adapter.
3. Plug the brake control adapter into the
vehicle electric controller connector f.
Use butt connectors and attach the wires
from the adapter to the corresponding
wires on the electric brake control,
following the brake control manufacturer's
installation instructions.
4. Complete the installation per the electric
brake control manufacturer’s instructions
and mount the unit as directed. Perform
test procedures as instructed.
NOTE
Vehicles not equipped with OEM trailer tow
package, may require fuses and relays to
complete output and battery feed circuits
(sold separately). Consult owners manual
for locations.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. 4 AXLES: 8 BRAKES (24 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
Electronic Trailer Brake Control
Wiring Adapter
Adaptateur pour câblage de commande
de frein de remorque électrique
Adaptador del cableado de control
eléctrico del remolque
•
d
•
f
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
TRAILER BRAKE CONTROLLER (OUTPUT)
CONTRÔLE DE FREIN DE REMORQUE (SORTIE)
CONDUCTOR DEL CONTROLADOR DE FRENO
(SALIDA) AL FRENO ELÉCTRICO DEL REMOLQUE
GROUND
MISE À LA TERRE
TIERRA
FUSED TRAILER BRAKE CONTROLLLER
BATTERY FEED
ALIMENTATION À FUSIBLE DE
LA BATTERIE AU CONTRÔLE DE FREINS
CONDUCTOR (CON FUSIBLE) DE
LA BATERIA AL CONTROLADOR
DEL FRENO DEL REMOLQUE
Wiring Adapter Housing (containing Male Terminals) - Wire Side
Logement de l'adaptateur de câblage (contenant les bornes mâles) - Côté fil
Protector del adaptador de cables (contiene los terminales machos) - Alambre el lado
VEHICLE STOP LAMP SWITCH TO BRAKE CONTROLLER (INPUT)
COMMUTATEUR DE FEUX D'ARRÊT DU VÉHICULE AU CONTROLE DE FREINS
INTERRUPTOR DE LUCES DE FRENADO DEL VEHICULO AL CONTROLADO DE FRENO (ENTRADA)
•
e