Draw-Tite 22291 PROPORTIONAL WIRING ADAPTER - Manual

22291-037 Rev. A 09/30/08
Installation Instructions
Directives de Montage
Instrucciones de Instalación
Electronic Trailer Brake Control
Wiring Adapter
Adaptateur pour câblage de commande
de frein de remorque électrique
Adaptador del cableado de control
eléctrico del remolque
•
d
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
ENGLISH
CAUTION
Plug brake control adapter into mating
receptacle on backside of brake control
before attaching to the vehicle connector
d.
1. Locate the vehicle’s electric brake control
harness. The harness will be located
underneath the dash and left of the steering
column, taped to another harness near the
emergency brake pedal
e. There will be a
4-pin connector that mates with the one on
the adapter
f.
2. Plug the brake control adapter into the
vehicle’s electric brake control harness
connector. Follow all brake control
manufacturer’s installation instructions.
NOTE:
Vehicles not equipped with OEM trailer tow
package, may require fuses and relays to
complete output and battery feed circuits
(sold separately). Consult owners manual
for locations.
WARNING
Complete the installation per the electric brake
control manufacturer’s instructions and mount
the unit as directed. Perform test procedures
as instructed.
WARNING
Overloading circuit can cause fires. DO NOT
exceed lower of towing manufacturer rating or:
• Max. 3 AXLES:
6 BRAKES 18 amps)
Read vehicle’s owners manual & instruction
sheet for additional information.
KIA Borrego
•
e
•
f
Emergency brake pedal
Pédale de frein de secours
Pedal de freno de emergencia
4-pin connector
Connecteur à 4 broches
Conector de 4 patas
4-pin connector
Connecteur à 4 broches
Conector de 4 patas
RED: VEHICLE STOP LAMP SWITCH
TO BRAKE CONTROLLER (INPUT)
ROUGE: COMMUTATEUR DE FEUX D'ARRÊT
DU VÉHICULE AU CONTROLE DE FREINS
ROJO: INTERRUPTOR DE LUCES DE FRENADO
DEL VEHICULO AL CONTROLADO
DE FRENO (ENTRADA)
Wiring Adapter Housing
(containing Male Terminals) -
Wire Side Logement de l'adaptateur de
câblage (contenant les bornes
mâles) - Côté fil Protector del adaptador de
cables (contiene los terminales
machos) - Alambre el lado
WHITE: GROUND
BLANC: MISE À LA TERRE
BLANCO: TIERRA
BLACK: FUSED TRAILER BRAKE
CONTROLLER BATTERY FEED
NOIR: ALIMENTATION À FUSIBLE DE LA
BATTERIE AU CONTRÔLE DE FREINS
NEGRO: CONDUCTOR (CON FUSIBLE) DE LA
BATERIA AL CONTROLADOR DEL
FRENO DEL REMOLQUE
BLUE: TRAILER BRAKE CONTROLLER
(OUTPUT)
BLEU: CONTRÔLE DE FREIN DE REMORQUE
(SORTIE)
AZUL: CONDUCTOR DEL CONTROLADOR DE
FRENO (SALIDA) AL FRENO ELÉCTRICO
DEL REMOLQUE