Draw-Tite 24808 SPORTFRAME HITCH User Manual
Installation instructions, Toyota prius, Part numbers

Installation Instructions
Toyota Prius
Part Numbers:
24808
60894
77179
Hitch Shown In Proper Position
Wiring Access Location: PC1,2
Equipment Required: Utility Knife
Wrenches: 10mm, 14mm, 17mm,
Small Flat Head Screwdriver
Frame rail
2
1
1.
Remove plastic cover panel from underneath the driver side of the vehicle.
2.
Remove tow hooks if present. Return tow hooks & fasteners to owner.
3.
Raise hitch into position and install fasteners into existing weldnuts as shown above.
4.
Torque all fasteners to specifications shown below.
5.
Plastic cover panel will need to be trimmed or not reinstalled on vehicle. Obtain vehicle owners approval before cutting.
With permission: Enlarge tow hook slot on plastic cover panel to fit around drivers side bracket.
6.
Reinstall trimmed cover panel removed in Step 1. Or return untrimmed panel to vehicle owner.
Tighten all M10 CL8.8 fasteners with torque wrench to 35 Lb.-Ft. (47 N*M)
Rev. A
2-21-08
24808N
Sheet 1 of 3
z
2008 Cequent Towing Products
Conical Washer
Qty. (4)
2
Bolt M10 X 1.25 X 30mm CL 8.8
Qty. (4)
1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3593
Fastener Kit: 24808F
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Note: Fasteners typical
both sides
NOTE! Plastic cover panels will need to be trimmed or not
reinstalled on vehicle. Get owner’s permission before starting
installation.
Weldnuts, typical both sides
Remove plastic rivet
Area to be trimmed
M6 bolts
Tow hook slot
Form F206 Rev A 5605