Draw-Tite 24819 SPORTFRAME HITCH User Manual
Installation instructions, Toyota yaris, Part numbers

Installation Instructions
Toyota Yaris
Part Numbers:
24819
60209
77191
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required:
Wrenches: 12mm, 13mm
Drill Bits: None
1.
Remove the two plastic fascia rivets from the fascia tabs (Do not discard).
2.
Remove the vehicle inboard bolt and the lower bolt located on each side of the end panel.
3.
Raise hitch into position.
4.
Install M8 bolts and conical toothed washers.
5.
Re-install the plastic fascia rivets removed in installation Step 1.
Rev. A
8-29-08
24819N
Sheet 1 of 3
z
2008 Cequent Towing Products
Conical Toothed Washer
Qty. (4)
2
M8 x 1.25 x 30mm, CL 10.9
Qty. (4)
1
Tighten all M8 CL10.9 fasteners with torque wrench to 27 Lb.-Ft (37 N-M).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3593
Fastener Kit: 24819F
Fascia
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
21
End panel
End panel
Note: Fasteners typical
both sides
Note: Rotate the hitch for
ease of installation.