Draw-Tite 24828 SPORTFRAME HITCH - Manual

Installation Instructions
Scion xD
Part Numbers:
24828
60214
77200
Hitch Shown In Proper Position
Wiring Access Location:
Equipment Required: Small Flat Head Screwdriver, Lubricant
or Soapy water
Wrenches: 12mm, 13mm, 9/16”, 11/16”, & 3/4” (2)
Fascia
Existing
weldnut
1. Remove appearance panel which covers the trunk pan. Remove the (7) plastic rivets that fasten the fascia tabs to the vehicle.
Note: Remove the center of the rivet with a screwdriver. Return appearance panel and fasteners to vehicle owner.
2. Remove existing M8 bolts (2) from end of each frame rail. Return fasteners to owner. See Figure 2.
3. Lower exhaust system at the rubber isolator. Note: Spraying a lubricant or soapy water on the metal hanger rod and the rubber
isolator helps removal.
4. Raise hitch into position over the exhaust.
5. Install fasteners as shown above. See Figure 1.
6. Tighten all fasteners to called-out torque specification
7. Raise exhaust system back into position.
Rev. A 10-17-08 24828N Sheet 1 of 3 z 2008 Cequent Towing Products
Hex nut 3/8-16 Qty. (2) 8 Conical washer 1/2” Qty. (2) 4
Conical washer 3/8” Qty. (4) 7 Spacer Qty. (4) 3
Hex bolt 3/8-16 X 1.75 GR5 Qty. (2) 6 Hex bolt 1/2-13 X 2.00 GR5 Qty. (2) 2
Hex nut 1/2-13 Qty. (2) 5 Hex bolt M8 X 1.25 X 35 CL9.8 Qty. (2) 1
Tighten all M8 CL9.8 fasteners with torque wrench to 17 Lb.-Ft. (23 N*M)
Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft. (41 N*M)
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in
the Rise position only.
Drawbar Kit:
3593
Fastener Kit: 24828F
Tie down bracket
1
34
5
37
8
2
67
Tie down
bracket
Figure 2.
Figure 1.
Remove
existing M8
bolts from end
of each frame
rail.
Note: Fasteners typical both sides
Exhaust not
shown for
clarity
Form F206 Rev A 5605