Draw-Tite 24732 SPORTFRAME HITCH User Manual
Installation instructions, Mitsubishi outlander, Part numbers

Installation Instructions
Mitsubishi Outlander
Part Numbers:
77048
24732
60824
Hitch Shown In Proper Position
Wiring Access Location: SUV3, SUV4
Equipment Required:
Wrenches: 10mm, 13mm, 14mm, & 17mm
Drill Bits: NONE
1.
Remove driver’s and passenger’s side tie-down brackets (if equipped). Return brackets and fasteners to vehicle owner.
2.
Remove the (3) fasteners holding the heat shield from the vehicle (muffler does not need to be removed).
3.
Trim the heat shield (figure 1) as shown. After trimming reattach heat shield.
4.
Raise the hitch into position and install fasteners as shown above into existing weld-nuts. Hand tighten only.
5.
Center the hitch receiver on vehicle and torque all fasteners to specification shown below.
z
2012 Cequent Towing Products
Sheet 1 of 3
N24732
2-7-12
Rev. E
Qty.
(6)
M10 x 1.25 x 40mm CL 8.8 Bolts
Qty.
(6)
Conical tooth washers
Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft (52 N*M).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
2000 lb (908 kg) Max Gross Trailer Weight
200 lb (90.8 kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
DrawBar must be used in
the RISE position only.
Drawbar Kit:
3591
Fastener Kit: F24732
Other: Tin Snips
1
2
Typical
both sides
PERMANENT REMOVAL OF TIE-DOWN BRACKETS MAY BE
REQUIRED. OBTAIN OWNER APPROVAL BEFORE REMOVING.
HEAT SHIELD TRIMMING REQUIRED. OBTAIN VEHICLE
OWNER APPROVAL BEFORE CUTTING.
NOTE!
Trim
1-1/2”
7”
Tie-Down
Brkt.
Frame
Rail
Heat
Shield
Muffler
Existing Weld-nuts
FIGURE 1.
HEAT SHIELD
Frame
Rail
1
2
24986 U-HAUL