Draw-Tite 24778 SPORTFRAME HITCH User Manual
Installation instructions, Kia optima kia magentis, Part numbers

Installation Instructions
Kia Optima
Kia Magentis
Part Numbers:
60848
24778
77154
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required:
Wrenches: 17mm., 3/4”
Drill Bits: None
1.
On dual exhaust models, loosen the rear exhaust hangers and lower the exhaust.
2.
Remove and dispose of rear rubber weld nut covers as shown in Figure 1.
3.
Raise hitch into position as shown in Figure 2.
4.
Tighten all fasteners.
5.
If necessary, raise the exhaust back into position and reattach to the exhaust hangers.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 lb-ft (57 N-m).
Rev. B
9-6-06
24778N
Sheet 1 of 3
z
2005, 2006 Cequent Towing Products
Nut
Qty. (1)
6
Carriage Bolt, 1/2 x 13 x 2”
Qty. (1)
3
Conical Washer, 1/2”
Qty. (1)
5
Conical Washer, 7/16”
Qty. (2)
2
Spacer
Qty. (1)
4
Hex Bolt, M10 x 1.25 x 40mm
Qty. (2)
1
Tighten all 1/2” GR5 fasteners with torque wrench to 50 lb-ft (68 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 lb. (908 kg) Max Gross Trailer Weight
200 lb. (90.8 kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3594
Fastener Kit: 24778F
Frame Rail
Fascia
Frame Rail
FIGURE 1
Rubber
Weld Nut
Cover
Both Sides
Existing
Weld Nuts
Both Sides
FIGURE 2