Draw-Tite 24843 SPORTFRAME HITCH User Manual
Installation instructions, Mazda 3 5-door, Part numbers

Installation Instructions
Mazda 3 5-Door
Part Numbers:
24843
60259
77245
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required: Pullwire (provided)
Wrenches: 11/16 & 9/16
Figure 2
1.
Use pull wires to feed the carriage bolts and blocks into frame rails though access holes as shown. Leave pull wire attached.
2.
Raise hitch into position, feed pull wires thru adjacent holes in the hitch, remove pull wires and attach flat washers, lock
washer and nut, finger tight only (Be careful not to push fastener back into frame rail). Hand tighten only until all fasteners
are installed.
3.
Install remaining fasteners as shown above.
4.
Torque all fasteners to specifications.
z
2009, 2011 Cequent Performance Products
Sheet 1 of 3
24843N
5-26-11
Rev. C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in
the RISE position only.
Drawbar Kit:
3594
Fastener Kit: 24843F
Form F206 Rev A 5605
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
j
Qty. (2)
Carriage bolt
– 7/16-14 X 1-1/2” GR 5
o
Qty. (2)
Hex bolt 3/8-16 X 2.00 GR5
k
Qty. (2)
Spacer
p
Qty. (2)
Flat washer
l
Qty. (2)
Flat washer 7/16”
q
Qty. (2)
Conical washer 3/8”
m
Qty. (2)
Lock washer 7/16”
r
Qty. (2)
Hex nut 3/8-16
n
Qty. (2)
Hex nut 7/16-14
j
k
l
m
n
po
Access holes
Tie down
hook
Fastener are typical
For both sides
Figure 1
Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft. (41 N*M)
Fascia
Existing hole
rq
l
m
n
po
j
k
qr