Draw-Tite 24826 SPORTFRAME HITCH User Manual
Installation instructions, Honda fit, Part numbers

Installation Instructions
Honda Fit
Part Numbers:
77198
24826
60218
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required: Screwdriver, Utility knife, Metal file
Wrenches: 11/16”
Drill Bits: None
1.
Remove the retainer holding the wheel well tab to bottom of frame rail on driver’s side. Trim wheel well tab so that the
hitch side bracket will sit flush against the bottom of frame rail. See figure 2.
2.
Cut a key hole notch in the rearmost hole in frame, both sides, so that the 1” wide spacer (item 2) will fit inside the frame
rail.
3.
Using pull wires provided, install carriage bolts and spacers into frame rail through the key hole into the forward holes.
4.
For the rearmost hole, fishwire the carriage bolts and spacer blocks into the rear hole and back down through hole.
See figure 3.
5.
First, raise the passenger’s side hitch bracket around the tailpipe, then raise the driver’s side of hitch up to frame and onto
carriage bolts. Do not install bracket on top of wheel well tab.
Note: Be careful not to push bolts and spacers back into frame.
6.
Install the conical toothed washers and hex nuts onto carriage bolts.
Rev. B
10-6-08
24826N
Sheet 1 of 3
z
2008 Cequent Towing Products
Conical Toothed Washer 7/16”
Qty. (4)
3
Pull wire, 7/16
Qty. (4)
5
Spacer 3/16” x 1 x 2
Qty. (4)
2
Hex Nut 7/16-14
Qty. (4)
4
Carriage Bolt 7/16-14 x 1.50 GR5
Qty. (4)
1
Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB (908 Kg.) Max Gross Trailer Weight
200 LB (90.8 Kg.) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3593
Fastener Kit: 24826F
Form F206 Rev A 5605
Fascia
Vehicle Frame
Remove
Wheel well tab
Fasteners typical
Both sides of vehicle
1
2
3
4
5
Key hole notch
Figure 1.
Figure 3.
Trim tab
From Wheel well
Figure 2.