beautypg.com

Draw-Tite 24791 SPORTFRAME HITCH User Manual

Installation instructions, Honda accord sedan acura 3.2 cl & tl, Part numbers

background image

Installation Instructions

Honda Accord Sedan

Acura 3.2 CL & TL

Part Numbers:

60913

24791

77165

Wiring Access Location: PC3

Equipment Required:

Wrenches: 3/4”

Drill Bits: NONE

1. Lower exhaust by removing rubber isolators from muffler hangers.
2. Thread bolt leader (3) onto 1 1/2" carriage bolt (1) and insert bolt leader through hole in reinforcing plate (2).
3. Fish bolt leader (3) and assembly through access hole in bottom of frame and carefully pull down through proper hole in frame. (refer to “Access

to Enclosed Frame” on last page of instruction sheet). Repeat for other side.

4. Raise hitch up to vehicle and install 2" carriage bolt (6), along with square hole spacer (7) through vehicle’s tie down hook, round hole spacer (8)

and hitch’s mounting tab in order as shown in illustration. Install conical toothed washer (5) and nut (4) and hand tighten to hold hitch in place.
Fish bolt leaders through holes in frame straps and being careful not to push bolt assemblies back into frame channels, remove bolt leaders and
install conical toothed washer (5) and nut (4).

5. Tighten all bolts, referring to torque table on instruction sheet.
6. Raise exhaust back into position and reinstall rubber isolators.

Rev. A

11-06-06

24791N

Sheet 1 of 2

z

2006 Cequent Towing Products

SPACER 1” X 2” X 1/4” (ROUND HOLE)

Qty. (1)

8

NUT 1/2”-13

Qty. (3)

4

SPACER 1” X 2” X 1/4” (SQUARE HOLE)

Qty. (1)

7

BOLT LEADER

Qty. (2)

3

BOLT – CARRIAGE 1/2”-13 X 2” GR 5

Qty. (1)

6

REINFORCING PLATE 1” X 3” X 1/4”

Qty. (2)

2

WASHER – CONICAL TOOTHED

Qty. (3)

5

BOLT – CARRIAGE 1/2”-13 X 1 1/2” GR 5

Qty. (2)

1

Tighten all 1/2 fasteners with torque wrench to 75 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2000LB (908Kg) Max Gross Trailer Weight

200 LB (90.8Kg) Max Tongue Weight

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in the
RISE position only.

Drawbar Kit:

3592

Fastener Kit: 24791F

1

2

3

5

6

5

7

8

4

4

Form F206 Rev A 5605