Draw-Tite 24673 SPORTFRAME HITCH User Manual
Installation instructions

Installation Instructions
Suzuki Grand Vitara,
Suzuki Vitara, (Includes XL-7),
Chevrolet Tracker 2 & 4 DR.
Part Numbers:
24673
60942
77023
Hitch Shown In Proper Position
Wiring Access Location: SUV3
Equipment Required:
Wrenches: 19mm
Drill Bits: None
2
1
Tie down
bracket
1. Remove driver’s side tie-down brackets (if equipped). Return brackets and fasteners to vehicle owner.
2. Raise the hitch into position and install fasteners as shown above into existing weld-nuts.
Rev. A
7-27-06
N24673
Sheet 1 of 3
z
2001, 2006 Cequent Towing Products
Conical Washer
Qty. (4)
2
Hex Bolt M12 X 1.25 X 40mm
Qty. (4)
1
Tighten all M12 CL8.8 fasteners with torque wrench to 67 Lb.-Ft. (91 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Drawbar Kit:
3591
Fastener Kit: 01131-124
Frame rail
Existing weldnuts
Fascia
Frame rail
Note: Fasteners typical
both sides
Existing M12 bolts
Form F206 Rev A 5605