Draw-Tite 24769 SPORTFRAME HITCH User Manual
Installation instructions, Dodge caliber, 12 3 fasteners typical both sides

Installation Instructions
Dodge Caliber
Except SRT4
Part Numbers:
60832
24769
77145
24732
U H l
Hitch Shown In Proper Position
Wiring Access Location: PC1, PC2
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Drawbar Kit:
3591
24732
U-Haul
Equipment Required:
Wrenches: 15/16
Fastener Kit: 24769F
il
1
2
3
Fasteners typical both sides
Bushing
Frame rail
1
Qty. (4)
Hex Bolt 5/8-11 X 4
3
Qty. (4)
Hex Nut 5/8-11
2
Qty (4)
Lock Washer 5/8
1.
Place 5/8 bolts into bushing from the outboard side of the frame rails. Leave flush with the inboard frame rail.
2.
Raise hitch into position and push 5/8 bolts through brackets to support hitch.
3.
Attached remaining fasteners as shown.
2
Qty. (4)
Lock Washer 5/8
Tighten all 5/8-11 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
z
2006, 2010, 2011 Cequent Performance Products
Sheet 1 of 3
24769N
3-1-11
Rev. E
g
q
(
)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form F206 Rev A 5605