Draw-Tite 24856 SPORTFRAME HITCH User Manual
Installation instructions, Ford fiesta sedan, Part numbers

Installation Instructions
Ford Fiesta Sedan
Part Numbers:
60272
24856
77229
Drawbar Kit:
3593
FASCIA
24849 U-Haul
Hitch Shown In Proper Position
Wiring Access Location: TBD
Equipment Required: Fishwire (provided)
2000LB (908Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
3593
F t
Kit 24856F
1
4
5
1
FRAME
Wrenches: 5/8”, 11/16”
Drill Bits: none
Fastener Kit: 24856F
FORWARDS
4
5
1
4
5
FRAME
EXTENSION
ACCESS
HOLE
FORWARDS
2
4
FORWARD
ATTACHMENT
HOLE
1
Qty. (2)
U-BOLT 7/16-20
5
Qty. (2)
BLOCKS – 3/16” X 1” X 2”
2
Qty. (4)
CONICAL WASHER – 7/16”
6
Qty. (2)
LOCK WASHER – 7/16”
3
Qty. (4)
NUT – 7/16”-20
7
Qty. (2)
NUT – 7/16”-14
PASSENGER SIDE FRAME RAIL SHOWN
2
3
67
2
3
1.
Place the U-bolts in rear most indentation in frame extension as shown.
2.
Raise hitch into place and loosely install the conical washers and 7/16-20 (fine thread) nuts.
3.
Using the fishwire (provided) insert coiled end thru forward attachment hole in hitch, into the frame, and out the access hole. Slide
block on and thread carriage bolt into the coil of the fishwire. Keep block and bolt separate until inside frame (see photo above).
Pull carriage bolt and block into position with the thread showing below hitch side bracket. Install lock washer and 7/16-14
(course thread) nut.
4.
Tighten all fasteners
4
Qty. (2)
CARRIAGE BOLT 7/16”-14 X 1-1/2”
8
Qty. (-)
-
z
2010 Cequent Performance Products
Sheet 1 of 3
24856N
11-16-10
Rev. B
Tighten all 7/16 fasteners with torque wrench to 50 Lb.-Ft. (68 n*m)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form F206 Rev A 5605