Draw-Tite 24863 SPORTFRAME HITCH - Manual (Page 2)

Installation Instructions
Ford Mustang
All models including V-6, V-6 Premium, GT 5.0 Liter, GT- Premium,
GT/California-Special & Shelby GT500 5.4 Liter
And convertible models of the above.
Part Numbers:
Tighten 7/16”-14 x 1-1/2” Carriage Bolts with torque wrench to 50 Lb.-Ft. (68 N*M)
z 2010, 2011 Cequent Performance Products
Sheet 2 of 6 24863N 05-26-11 Rev. C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Loosen these bolts on
exhaust so that mufflers can
be rotated downward, after
removing muffler hanger
tangs out of rubber isolators
typical both sides of vehicle
shown above.
Muffler hanger tang
Rubber isolator
Access hole
Picture 1.
Picture 2.
Picture 3.
Outside of Passenger’s side
frame rail shown with ends of
Bolt Leaders sticking out.
Be careful not to push ends
back in to frame when raising
hitch up in to place.
Slide hitch bracket up in
place between outside of
frame and inside of this
bolt, typical both sides.
24863
60280
77238
24843
(U-Haul)