Draw-Tite 24747 SPORTFRAME HITCH User Manual
Installation instructions, Ford mustang, Part numbers

Installation Instructions
Ford Mustang
Part Numbers:
60809
24747
77124
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required: Drill
Wrenches: Ratchet, Extension, 13mm, 11/16
Drill Bits: 3/8”
1
Frame rails
1. Remove rear exhaust hanger and the hanger above the muffler, this will need to be done on both sides on models with dual exhaust.
2. You will need to open up the hole in the horizontal arm of the exhaust hanger at the rear of the vehicle on the passenger side or bend
exhaust hanger to allow installation after hitch is installed.
3. Using the bolt leaders, fish the hardware into the frame and let it sit inside the frame with the bolt leader tails hanging out through the
appropriate holes.
4. Raise hitch up into place making sure to align horizontal arm on the rear exhaust hanger on the passenger side with the large oblong hole in
the frame bracket as you are raising the hitch up into position between the two frame rails, also you will need to insert the ends of the bolt
leaders through the holes frame brackets.
Note: you may need the assistance of another person to help hold the hitch in place until you get the hardware pulled into through the frame
brackets, see illustration for clarification.
5. Remove bolt leaders and install nuts on the bolts and install the m8 bolt through the vertical arm of the rear exhaust hanger on the passenger
side and the frame bracket into the frame.
6. Tighten all fasteners as required.
7. Reinstall the remaining exhaust hangers and make sure all the necessary hardware is back in place.
Tighten all 7/16 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Rev. C
5-8-06
60809N
Sheet 1 of 3
z
2005, 2006 Cequent Towing Products
Conical Washer 7/16
Qty. (4)
3
Flange Bolt M8 X 1.25 X 35
Qty. (1)
5
Spacer
Qty. (4)
2
Hex Nut 7/16-14
Qty. (4)
4
Carriage Bolt 7/16-14 X 1.50
Qty. (4)
1
Tighten all M8 CL8.8 fasteners with torque wrench to 20 Lb.-Ft.(27 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Drawbar Kit:
3592
Fastener Kit: 60809F
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
24777
Exhaust hanger
(See Note 2)
2
43
5
Fascia
Form F206 Rev A 5605