Draw-Tite 36490 FRAME HITCH User Manual
Installation instructions, Toyota rav4, Part numbers

Installation Instructions
Toyota RAV4
Part Numbers:
36490
06668
90207
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 17mm, 19mm
Drill Bits: None
1.
Remove tie down bracket from the driver’s side of the vehicle and return to vehicle owner.
2.
Raise hitch into position over existing weldnuts and install the M12 bolts and conical toothed washers as shown above.
Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft.
z
2009, 2012 Cequent Performance Products
Sheet 1 of 3
36490N
1-9-12
Rev. B
j
Qty. (4)
M12 X 1.25 X 40mm CL10.9
k
Qty. (4)
½” Conical Toothed Washer
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 36490F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: SUV3, SUV4
Frame Rail
Fascia
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Carrying
Ball Mount
3500 (1589 Kg.)
300 (136 Kg.)
Drawbar Kit:
36051
Drawbar must be
used in the Rise
position only.