Draw-Tite 36535 FRAME HITCH - Manual

Installation Instructions
Lexus GS350
Part Numbers:
36535
90232
06945
Hitch Shown In Proper Position
Equipment Required: Utility Knife, Marker,
Tape measure, body panel tool
Wrenches: 10mm socket, 12mm socket,
Ratchet, 6” socket extension
Phillips screw driver, Flat screw driver
z
2013 Cequent Performance Products, Inc. Sheet 1 of 2 36535N 12-6-13 Rev C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 36535F
Wiring Access Location: PC3, PC4
Form: F205 Rev A 5-6-05
Tighten all M8-1.25 CL10.9 fasteners with torque wrench to 25Lb.-Ft. (34 N*M)
IMPORTANT NOTE! The bumper cover requires trimming to install hitch. Consult with vehicle owner before proceeding with install.
1.
Remove bumper cover (Fascia) by removing (1) screw from behind rear tire at bottom of fascia, both sides
2. Next, remove (1) screw hidden behind inner wheel well at the top of the fascia. Remove the plastic clip by pulling center out
with a flat screw driver, both sides.
3. Open trunk lid and remove small round plastic panel located between tail light and trunk opening. Remove the screw, both
sides.
4. Remove center (4) push fasteners from the rear underside of the fascia, using a flat screw driver.
5. Carefully remove bumper cover, starting with the sides first. Use a plastic body panel tool to separate the plastic fascia along
the seam. Note: Unplug back-up sensor wiring. (continued page 2)
Vehicle End
Panel
Figure 2.
Figure 1.
Vehicle fascia
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
3500 Lb. (1589 kg) Max Gross Trailer Weight
300 Lb. (136 kg) Max Tongue Weight
Drawbar must be used in the
Rise position only.
Drawbar Kit:
36071
(All models)
3-1/8”
1-1/2”
Bottom View of Bumper Cover
Accessory Rating B
Printed in Mexico
Vehicle M8
factory bolts