Draw-Tite 36282 FRAME HITCH - Manual

Installation Instructions
Lincoln LS
*For 2003 Models Additional
Installation Time Required
Part Numbers:
90143
36282
06393
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required: Utility Knife, Fishwire (provided)
Wrenches: 11/16
Drill Bits: 7/16
For 2003 Models Fascia Trimming Is Required
1. Disconnect the two (2) fascia tabs holding the lower fascia to the trunk pan.
2. Fishwire the forward fasteners in the frame rail as Shown above.
3. Apply the Galvanic isolator shields to the blocks and hitch tabs that contact the aluminum bumper.
4. Raise the hitch into position and attach with forward fasteners. On 2003 vehicles, notch fascia as necessary. Obtain vehicle
owners approval before cutting
5. Using the hitch as a template, drill two (2) 7/16” holes in the bumper.
6. Fishwire carriage bolts and blocks thru holes in bumper and install lock washers and nuts.
7. Reattach the lower fascia tabs with cable ties provided.
Rev. C 3-8-06 N36282 Sheet 1 of 3 z 1999, 2001, 2003, 2006 Cequent Towing Products
Galvanic Isolator Shield (not shown) Qty. (8) 5 Block Qty. (4) 2
Cable Tie (not shown) Qty. (2) 6 Lock Washer 7/16 Qty. (4) 3
Hex nut 7/16-14 Qty. (4) 4 Carriage Bolt 7/16-14 X 1.50 Qty. (4) 1
Tighten all 7/16-14 GR fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
36071
Fastener Kit: K36282
Frame rail
Bumper
Fascia
Fascia trim required. Obtain vehicle
owners approval before cutting
Fascia trim required. Obtain vehicle
owners approval before cutting
Frame rail
Access hole
Bottom of Fascia Drilled hole
Fascia
Disconnect lower fascia tabs and
reattach using cable ties provided
IMPORTANT
Install two (2) galvanic
isolator shields per
bumper mounting block.
Isolator shield must be
placed between block
and aluminum bumper
IMPORTANT
Install two (2) galvanic
isolator shields per
bumper mounting tab.
Isolator shields must be
placed between hitch
and aluminum bumper
1
3
2
4
Fasteners typical both sides.
2003 Vehicles
Both sides
Form F206 Rev A 5605