Draw-Tite 36363 FRAME HITCH User Manual
Installation instructions, Hyundai tucson kia sportage, Part numbers

Installation Instructions
Hyundai Tucson
Kia Sportage
Part Numbers:
06339
36363
Hitch Shown In Proper Position
Wiring Access Location: SUV1, SUV2
Equipment Required:
Wrenches: 13mm, 14mm, 17mm
Drill Bits: None
Hitch Requires ½” Pin and Clip
1.
Lower exhaust by removing two (2) rubber exhaust hangers on the driver’s side of the vehicle and one (1) on the passenger’s
side of the vehicle.
2.
Remove tow hook bracket (see figure 2) by removing five (5) M10 bolts and return to vehicle owner.
3.
Raise hitch into position and install four (4) M10 X 1.25 X 40mm bolts and conical toothed washers, two (2) per side.
Rev. B
03-10-06
36363N
Sheet 1 of 3
z
2006 Cequent Towing Products
3/8 Conical Toothed Washer
Qty. (4)
2
M10 X 1.25 X 40mm CL 8.8
Qty. (4)
1
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
3500 LB Max Gross Trailer Weight
300 LB Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Fastener Kit: 36363F
Figure 2
Fasteners Typical Both Sides
Existing Weldnuts
Frame Rail
Fascia
Bumper
Structure
Drawbar Kit:
36051