Draw-Tite 36362 FRAME HITCH - Manual

Drawbar must be used in the
DROP position only.
Bumper
Fascia
Bumper
Structure
Hitch Shown In Proper Position Fascia
Bumper
Structure
Pins
FIGURE 1 FIGURE 2
Drawbar Kit:
36051
Or
90001
Installation Instructions
Jeep Grand Cherokee
Jeep Commander
Part Numbers:
06378
36362
90114
Rev. C 8-7-06 36362N Sheet 1 of 3 z 2005, 2006 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Wiring Access Location: SUV1, SUV2
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 N*M) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle Manufacturer’s
Rating or
Equipment Required:
Wrenches: 3/4”
Fastener Kit: 36362N or 90114N
Conical Washer, 1/2” Qty. (4) 2
Flat Washer, 1/2” Qty. (8) 3 Hex Bolt, 1/2-13 x 4” Qty. (4) 1
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch
installation. Installation time will increase from 20 Min. to 90 Min.
1. Lower the spare tire.
2. Remove two plastic pins that hold bumper fascia onto bumper structure as shown in Figure 1. (If OEM tow hook is present:
Remove fascia, plastic bumper support and tow hook)
3. Gently pull fascia rearward about one inch and raise the hitch into position as shown in Figure 1.
4. If there is excessive gap between the vertical surfaces of the hitch and the bumper structures, flat washers should be used as
shims. They can be held in place using cellophane tape. See Figure 2.
5. Secure hitch with fasteners. Fascia may contact the back of the hitch. (Reinstall fascia and plastic bumper support if removed
in Step 2.)
6. Replace plastic pins in bumper fascia.
7. Raise the spare tire into storage position.
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (120 N*M)