Draw-Tite 36451 FRAME HITCH - Manual

Installation Instructions
Jeep Liberty
Part Numbers:
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm
Drill Bits: NONE
1. Raise hitch into position.
2. Install fasteners as shown above.
3. Tighten all fasteners to 68 Lb-Ft (92 N*M).
Rev. A 8-1-07 36451N Sheet 1 of 3 z 2007 Cequent Towing Products
Conical Toothed Washer 1/2 Qty. (4) 2 Hex Bolt M12 X 1.75 X 40mm CL 8.8 Qty. (4) 1
Tighten all M12 CL 8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 36451F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: SUV 1, 2
Weldnuts –
Both sides
Vehicle Support
Bracket
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
2
1
36451
90168
06529
Note: Fasteners typical
both sides
Drawbar Kit:
36071
Drawbar must be used in the
Drop position only.
Form: F205 Rev A 5-6-05