Draw-Tite 36508 FRAME HITCH User Manual
Installation instructions
Installation Instructions
Part Numbers:
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required: Lubricant or Soapy water
Wrenches: 10mm, 13mm, 15mm, 19mm, & 3/4”,
6” Ratchet extension, Ratchet swivel socket
Access slot
Existing
weldnuts
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
36061
Fastener Kit: 36508F
36508
90209
06129
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
2
2
2
2
4
4
4
4
3
3
3
3
3
3
3
32
2
2
21
1
1
1
Access hole
Frame rail
Fascia
Figure 3.
2011 and newer V8 models - remove and
save (2) assembly bolt and spring from the
flange (nut and spring are attached).
Chrysler 300 / 300C,
Dodge Magnum SE, SXT, & RT,
Dodge Charger, Dodge Challenger
Check guides for year and fits
z
2011 Cequent Performance Products
Sheet 1 of 6
36508N
7-7-11
Rev. A
1
1
1
1
Qty. (3)
Hex Bolt ½-13 x 1-1/2 GR5
3
3
3
3
Qty. (3)
Handle Nut Assembly 1/2-13
2
2
2
2
Qty. (6)
Conical Washer 1/2”
4
4
4
4
Qty. (3)
Hex Bolt M12 x 1.75 x 40mm CL8.8
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form F206 Rev A 5605
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Tighten all 1/2-13 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
2
2
2
2
4
4
4
4
2
2
2
2
1
1
1
1
Access hole
Figure 2.
Set-up handle nut assembly prior to
installation. Both side as shown.
Gently push muffler up and
outward for clearance if needed.
Figure 4.
2011 and newer V6 models remove and
save band clamp, separate exhaust pipes
and remove muffler.
Figure 1.
Band clamp