Draw-Tite 36424 FRAME HITCH - Manual

Installation Instructions
Jeep Wrangler
Jeep Wrangler Unlimited
Part Numbers:
36424
90157
06448
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”
Drill Bits: None
1
Crossmember
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch installation.
1.
Lower exhaust. (If required)
2. Raise hitch into position.
3. Install fasteners as shown above.
4. Reinstall the vehicle exhaust. (If required)
Rev. A 8-23-06 36424N Sheet 1 of 3 z 2006 Cequent Towing Products
Conical Washer Qty. (4) 2 Hex Bolt 1/2-13 X 4.50 Qty. (4) 1
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 36424F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: TBA
2
Crossmember
Bumper
Spare tire
Drawbar must be used in
the Drop position only.
Drawbar Kit:
36071
Optional
36078
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
Form: F205 Rev A 5-6-05