Draw-Tite 75448 MAX-FRAME RECEIVER User Manual
Installation instructions, Suzuki grand vitara, Part numbers

Installation Instructions
Part Numbers:
44543
75448
87007
Hitch Shown In Proper Position
Drill Bits: N/A
Rev. B
6-10-08
75448N
Sheet 1 of 3
z
2005, 2008 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75448F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350
3500
Weight Carrying
Ball Mount
400
4000
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Form: F205 Rev A 5-6-05
Wiring Access Location: SUV3, SUV4
Equipment Required: Utility Knife
Wrenches: 19 mm, Torque Wrench
Figure 1.
License Plate Mounting Location
8"
1-1/4"
1-1/4"
1.
Notify vehicle owner that the fascia requires minor trimming to fit hitch.
2.
Using a felt tipped pen, measure and mark an outline on the fascia described in Figure 1.
3.
Using a utility knife, carefully cut out the fascia on the bottom inside section of the license plate mounting area as shown.
4.
Raise hitch into position, aligning the holes in hitch with the two rearmost weldnuts in the bottom of frame rail, both sides.
5.
Loosely install the M12 hex bolts and conical toothed washers, four places. Center hitch on fasteners.
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft.
Conical Toothed Washer ½
Qty. (4)
2
Hex Bolt, M12 x 1.25 x 35mm CL8.8
Qty. (4)
1
Suzuki Grand Vitara
Spare Tire
Fascia
Frame Rail
Existing Weldnuts - Typ.
Figure 2.
2
1
Fascia
Area to Trim