Draw-Tite 75144 MAX-FRAME RECEIVER User Manual

Installation instructions, Product no

INSTALLATION INSTRUCTIONS

Product No.

33022

75144

87490

SMALL PARTS

PACKAGE 36573

PLYMOUTH, MI

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY Towing Products SUPPLIED OR APPROVED BOLTS,
LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH

(OVER)

TOYOTA T100 PICKUP

2WD & 4WD

1. All trucks, remove the two inner bolts along the bottom of the bumper using an allen wrench.

2. 4x4 trucks, Remove the four (2 each side) 12mm bolts that secure the frame reinforcement to the frame. This is

inside the frame - above the leaf spring.

3. Install the frame brackets (A) and (B) with the flanges pointing outward. Position the brackets over the holes where

the hardware was removed. Install bolt (D), lock washer (H), serrated washers (J), and nut (I). On 4x4 trucks, use
the existing nuts in the reinforcement brackets. On 2wd trucks, use the existing nut in the frame. When you have
finished installing this hitch on a 4x4 truck, there will be extra nuts and washers remaining in the parts bag.

(J) SERRATED WASHER

(I) NUT

(J) SERRATED WASHER

(D) M12 X 1.25 X 35mm BOLT
(H) HELICAL LOCK WASHER

(E) 3/8-16 X 1-1/4 LG. BOLT
(F) 3/8 HELICAL LOCK WASHER
(L) 3/8 SERRATED WASHER

(A) LEFT FRAME BRACKET

(B) RIGHT FRAME BRACKET

TOOLS REQUIRED

9/16" SOCKET
18mm WRENCH
7/32" ALLEN WRENCH
TORQUE WRENCH

NOTE: FASTENERS TYPICAL

BOTH SIDES

(K) BUMPER BAR

(H) HELICAL LOCK WASHER

(D) M12 X 1.25 X 35mm BOLT

(I) NUT

TWO WHEEL DRIVE
ATTACHMENT HOLES

ATTACHMENT HOLES

FOUR WHEEL DRIVE