Draw-Tite 75644 MAX-FRAME RECEIVER - Manual

Installation Instructions
Nissan Armada
Part Numbers:
44596
75644
87476
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm
Drill Bits: None
1. Raise hitch into position, aligning holes in hitch with the existing weldnuts in vehicle frame rails.
2. Install M12 hex bolts, lock washers & flat washers as shown (hand tighten only until all fasteners are installed).
Rev. A 11-20-07 75644N Sheet 1 of 3 z 2007 Cequent Towing Products
Lock Washer – 1/2 Qty. (6) 2
Flat Washer – 1/2 Qty. (6) 3 Hex Bolt M12 x 1.25 x 45mm CL8.8 Qty. (6) 1
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75644F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 (272 Kg) 6,000 (2724 Kg)
Weight Carrying
Ball Mount
1,000 (454 Kg) 10,000 (4540 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV6
Form: F205 Rev A 5-6-05
Fascia
Vehicle Frame
rail
123
Fasteners Typical
Both Sides
Vehicle
Frame
Rail