Draw-Tite 75606 MAX-FRAME RECEIVER - Manual

Installation Instructions
Nissan Rogue
(Except Krōm)
Part Numbers:
75606
87457
44592
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75606F
Manufacturer s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distribution Not to be used with Spring bars
Weight Carrying
Ball Mount
3500 (1590 Kg) 350 (159 Kg)
Wiring Access Location: SUV1 & SUV2
Wrenches: 18 & 19mm
Drill Bits: None
21
V hi l F
Factory Tow Hook
Vehicle Frame
1 Qty. (6) Hex Bolt M12 x 1.25 x 35mm CL8.8 2 Qty. (6) Conical Washer ½”
Fasteners typical for all
mounting locations
1. Remove and return factory tow hook and fasteners to vehicle owner.
2. Raise hitch into position on driver’s side and loosely install center fastener as shown, installing hex bolt and conical washer thru
elongated hole in hitch into vehicle frame. Raise hitch into position on passenger’s side and loosely install center fastener as
shown, installing hex bolt and conical washer thru elongated hole in hitch into vehicle frame. Center hitch on vehicle and install
remaining hardware as shown.
z 2007, 2010 Cequent Performance Products Sheet 1 of 3 75606N 7-16-10 Rev. C
Tighten all M12 x 1.25 CL8.8 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05