Draw-Tite 75685 MAX-FRAME RECEIVER - Manual

Installation Instructions
Lexus GX460
Part Numbers:
75685
87580
44644
75209 U-Haul
Hitch Shown In Proper Position
Wiring Access Location: Equipment Required:
Wrenches: 19mm
Drill Bits: NONE
1. Raise hitch into position.
2. Install fasteners into existing weldnuts as shown above.
3. Torque all fasteners to specifications.
Rev. B 3-3-10 75685N Sheet 1 of 3 z 2010 Cequent Performance Products
Conical Washer 1/2” Qty. (4) 2 Bolt M12 x 1.25 x 35mm CL8.8 Qty. (4) 1
Tighten all M12 CL 8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
.
Fastener Kit: 75685F
Form F206 Rev A 5605
500 (227 Kg) 5000 (2270 Kg)
Weight Carrying
Ball Mount
500 (227 Kg) 5000 (2270 kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
2
1
Fascia
Weldnuts
Vehicle bumper bracket.
Note: Fasteners typical
both sides