Draw-Tite 75519 MAX-FRAME RECEIVER - Manual

Installation Instructions
Mitsubishi Endeavor
Part Numbers:
75519
44561
87428
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 12mm, 17mm
Drill Bits: None
Rev. A 12-13-06 75519N Sheet 1 of 3 z 2006 Cequent Towing Products
7/16” Conical Toother Washer Qty. (6) 2 M10 X 1.25 X 30mm Hex Bolt Qty. (6) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75519F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350 (159 kg) 3500 (1589 kg)
Weight Carrying
Ball Mount
NA NA Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV1, SUV2
Form: F205 Rev A 5-6-05
1. Lower the vehicle exhaust by removing the rubber isolator.
2. Raise hitch into position and align with existing weldnuts in the frame rails.
3. Loosely install the M10 X 1.25 X 30mm hex bolts and conical toothed washers on passenger side of vehicle.
4. Install fasteners on driver side of vehicle and tighten all fasteners.
5. Raise exhaust back into position by re-installing rubber isolator.
Fascia
Tighten all M10 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M)
Frame Rail
Existing weldnuts
both sides of vehicle
Frame Rail