Draw-Tite 75741 MAX-FRAME RECEIVER - Manual

Installation Instructions
Nissan Armada
Infiniti QX56
Part Numbers:
87620
75741
44674
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm
Fastener Kit: 75741F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 10,000 (4540 Kg) 1,000 (454 Kg)
Weight Carrying
Ball Mount
6,000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: SUV6
Fasteners Typical
Both Sides
Fascia
2
3
1
1. Raise hitch into position, aligning holes in hitch with the existing weldnuts in vehicle frame rails.
2. Install M12 hex bolts, lock washers & flat washers as shown (hand tighten only until all fasteners are installed).
z 2011 Cequent Performance Products Sheet 1 of 3 75741N 10-14-11 Rev. A
1 1 1 1 Qty. (6) Hex Bolt M12 x 1.25 x 45mm CL8.8 3 3 3 3 Qty. (6) Flat Washer – 1/2
2 2 2 2 Qty. (6) Lock Washer – 1/2
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05