Draw-Tite 75699 MAX-FRAME RECEIVER User Manual
Installation instructions, Jeep grand cherokee, Part numbers

Installation Instructions
Jeep Grand Cherokee
Excluding EcoDiesel Models
Part Numbers:
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 21mm
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch
installation
1. Remove (4) existing M14 bolts (Do Not clean the threads). Retain bolt for reinstallation.
2. Raise hitch into position as shown and install fasteners as shown. If excess caulking on the
frame rail interferes with hitch installation lower hitch and scrape excess caulking for installation.
3. Tighten all fasteners to called-out torque specification
Tighten all M14 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
z
2010, 2014 Cequent Performance Products –
Printed in Mexico
Sheet 1 of 3
75699N
1-24-14
Rev. C
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75699F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
7500 (3405 Kg)
750 (341 Kg)
Weight Carrying
Ball Mount
5000 (2270 Kg)
500 (227 Kg)
Form: F205 Rev A 5-6-05
Frame rails
Frame rail
Fascia
Retain bolt for
reinstallation.
Existing weldnut
both sides
Note: Fasteners typical
both sides
Note: Uses all
existing Bolts
on Vehicle
75699
87595
44650
Accessory Rating
C
Wiring Access Location: 2011-13 SUV 1, 2
2014- SUV 3, 4