Draw-Tite 75806 MAX-FRAME RECEIVER User Manual
Installation instructions, Acura mdx, Part numbers

Installation Instructions
Acura MDX
Part Numbers:
75806
44700
87649
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 22MM
Drill Bits: None
Fastener Kit: 75806F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
8000 Lb (3628 Kg)
900 Lb (409 Kg)
Weight Carrying
Ball Mount
6000 Lb (2724 Kg)
900 Lb (409 Kg)
Wiring Access Location: SUV1, SUV2
Fascia
Frame rail
Accessory Rating
C
1. Lower and remove spare tire from vehicle.
2. Raise hitch into position and insert M14 bolts and conical washers through the bracket and frame as shown in Figure 1.
3. Reinstall spare tire and make sure it is seated properly
4. Torque all fasteners to the specifications shown below.
z
2013 Cequent Performance Products, Inc.
Sheet 1 of 3
75806N
08/07/13
Rev.A
1
1
1
1
Qty. (6)
M14 x 1.50 x 45 Bolt CL10.9
2
2
2
2
Qty. (6)
5/8 Conical washer
Tighten all M14 CL10.9 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fasteners typical both sides
12
Figure 1
Form: F205 Rev C 9-17-2012