Draw-Tite 75146 MAX-FRAME RECEIVER - Manual

INSTALLATION
INSTRUCTIONS
Product No.
33003/75146
PLYMOUTH, MI BUICK ROADMASTER,
CHEVROLET CAPRICE,
& CADILLAC FLEETWOOD
SMALL PARTS
PACKAGE 36364
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY SUPPLIED OR APPROVED BOLTS, LOCKNUTS, AND
WASHERS TO INSTALL THIS HITCH
(OVER)
TOOLS REQUIRED
15 mm WRENCH
15 mm SOCKET
3/4" SOCKET
9/16" DRILL
TORQUE WRENCH
1/2" SERRATED WASHER
1/2" NUT
EXISTING NUT
3/8" RIB NECK BOLT
1/2" CARRIAGE BOLT
BOLT PLATE
SMALL SPACER
5/16" SERRATED WASHER
M8 HEX BOLT
3/8" LOCK WASHER
3/8" NUT
NOTE: DO NOT LUBRICATE THREADS AS IT MAY CAUSE BOLT FAILURE DUE TO OVERTIGHTENING.
This receiver hitch is sized 2" square. Hitch bar must insert 5-3/4" minimum.
1. Remove four metric bolts (two per side) which fasten the Energy Absorbing cylinders to the frame. Save the nuts. Discard the
bolts.
CAUTION: BOLT PLATE LOCATION WITHIN THE FRAME IS CRITICAL. BOLT HOLES MUST BE LOCATED AND DRILLED
TO THESE INSTRUCTIONS TO INSURE SAFE FRAME LOADING. IMPROPER HOLE LOCATION WOULD RESULT IN
ATTACHMENT FAILURE. TRAILER SEPARATION FROM CAR COULD RESULT.
1/2" LOCK WASHER
33003IN-12-17-02A PCN6053 © 2002 TOWING PRODUCTS, INC. Litho in USA