Draw-Tite 75725 MAX-FRAME RECEIVER User Manual
Installation instructions
Installation Instructions
Part Numbers:
75725
87614
44668
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 7/8, 22mm
Drill Bits: None
Fastener Kit: 75725GF
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
10,000 (4540 Kg)
1000 (454 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg)
900 (409 Kg)
Wiring Access Location: SUV6
1
2
Frame rail
Bumper
Bumper bracket
Hole not used
(Both sides)
Bumper
Frame rail
Existing weldnut
All require OEM Bumper
Chevrolet Suburban*, Chevrolet Tahoe*,
GMC Yukon XL*, GMC Yukon*,
Cadillac Escalade, Chevrolet Avalanche,
*Vehicles with amber turn signals
© 2011 Cequent Performance Products
Sheet 1 of 3
75725N
7-28-11
Rev. A
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form: F205 Rev A 5-6-05
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Tighten all M14 CL10.9 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
1
1
1
1
Qty. (2)
Carriage Bolts 1/2-13 X 1.75 GR 5
5
5
5
5
Qty. (4)
Hex Bolt M14 X 2.00 X 40mm CL 10.9
2
2
2
2
Qty. (2)
Spacer
6
6
6
6
Qty. (4)
Lock Washer
3
3
3
3
Qty. (2)
Conical Washer
7
7
7
7
Qty. (4)
Flat Washer
4
4
4
4
Qty. (2)
Hex Nut 1/2-13
1. Remove existing M14 bumper bracket bolts on both sides from bottom surface of frame and return to vehicle owner.
2. Raise hitch into position and install as shown with fasteners provided.
Note: Fasteners typical
both sides
7
6
5
3
4
Existing weldnut
Inside of bumper