Draw-Tite 41541 MAX-E-LOADER RECEIVER - Manual

Installation Instructions
Lexus RX300
Toyota Highlander
Part Numbers:
41541
78229
U-Haul
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Fascia
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 14mm, 17mm
Drill Bits: None
Fastener Kit: K41541
Manufacturer s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing Do Not Use With Spring Bars
Weight Carrying
Ball Mount
3500 (1589 Kg.) 350 (159 Kg.)
Wiring Access Location: SUV1, SUV2
Frame Rail
Existing Weldnut
Fasteners Typical
Both Sides
1. Remove tow hooks from frame rails and return to vehicle owner.
2. Remove plastic caps in forward attaching holes.
3. Raise hitch into position and install fasteners as shown above.
Ti ht
ll M10 1 25 CL10 9 f t ith t h t 42 Lb Ft (57 N*M)
1 Qty. (6) Hex Bolt M10 x 1.25x 30mm CL10.9 2 Qty. (6) Conical Toothed Washer 3/8”
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
z 2000, 2001, 2009, 2011 Cequent Performance Products Sheet 1 of 3 N41541 4-8-11 Rev. B
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Form: F205 Rev A 5-6-05