Draw-Tite 41946 ULTRA FRAME RECEIVER - Manual

Installation Instructions
GMC Full Size Van
Part Numbers:
41946
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 13/16”, 15/16”
Drill Bits: 9/16”
1. Enlarge existing holes to 9/16” (8 places)
2. Insert bolts, brackets, and block through existing access slots and into attachment holes as shown above, each side.
3. Raise hitch into position and fasten with flat washers, lock washers, and nuts as shown
4. Tighten all fasteners.
© 2012 Cequent Performance Products, Inc Sheet 1 of 3 41946N 1-27-12 Rev. X
j
Qty. (10) BOLT- HEX 9/16”-12 X 1.75 GR5 n
Qty. (10) NUT – 9/16-12
k
Qty. (2) BLOCK – 3/8” X 1-1/2” X 3”
o
Qty. (2) BLOCK – 1/4” X 1-1/2” X 2”
l
Qty. (14) WASHER – FLAT 9/16” p
Qty. (1) BRACKET – L.H.
m
Qty. (10) WASHER – LOCK 9/16” q
Qty. (1) BRACKET – R.H.
Tighten all 9/16” fasteners with torque wrench to 110 Lb.-Ft. (149 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 41946F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 13,000 (5902 Kg) 1,300 (590 Kg)
Weight Carrying
Ball Mount
10,000 (4540 Kg) 1,500 (681 Kg)
Wiring Access Location: SUV3, SUV4
Form: F205 Rev B 11-11-2010
j
k
l m
p
q
j
o
n
l m n
l m n
j
l
FASTENERS ARE TYPICAL
BOTH SIDES
BUMPER
FRAME