BEI Sensors MHK5 Absolute Hollow Shaft Encoder - Manual (Page 34)

7.4 Setting the parameters
Select the encoder in the hardware configuration
and double click slot one in the configuration table
of the encoder. The dialog „Properties – DP slave“
appears. The input and output addresses can be
changed (if desired). To set the encoder
parameters the tab “Parameter Assignment” has to
be selected.
After choosing the „Device-specific parameters“
the different parameters (depend on the encoder
version) can be set.
If several possibilities are offered for one
parameter the parameters list is opened by double
clicking on it. Numerical values have to be entered
directly. The example shows the parameters of
encoder version 2.2, the version with the highest
functionality.
Page 34 BEI Sensors Profibus Manual serie M Revision 03/10