CEMB USA C75 (A) User Manual

Page 15

I 0202 - 15

5.3.2 - MANUAL PRESETTING

If necessary, the dimensions can be inserted or edited in manual mode as follows:

- press

or else press

from the Dimensions in automatic mode

screen (which can be reached by pulling out the distance + diameter gauge).

- press

to select the dimension to be preset (red).

- press

to preset the required value.

- press

to change unit of measurement.

- press

to preset the dimensions for the ALU-S correction mode

Defi nition of dimensions for correction using spring weights:
d = DIAMETER:

Preset the nominal diameter stamped on the rim.

b = WIDTH:

Preset the nominal width indicated on the rim.

a = DISTANCE:

Preset the distance of the inside of the wheel from the machine, after measuring

it with relative gauge as described in fi g. 8.

In the event of correction type other than standard (spring weight), follow the instructions on the screen
for correct detection of dimensions.

Fig. 10a