MoTeC ADL2 EDL2 - Manual (Page 68)

66 Appendices
Appendix J: USB Wiring
The USB connection should be made by wiring a USB cable to the ADL2
main connector as shown below:
The USB cable should have a type B socket so that a standard USB A to B
cable can be used to connect between it and the PC. MoTeC can provide a
suitable cable (these are not commonly available).
Note that the maximum length from ADL to the PC is 5m (16ft) when using a
normal USB cable. This can be extended in steps of 5m (16ft) up to a
maximum of 25m (80ft) by using Active USB extender cables or hubs.
Wiring Details:
70
77 USB-VCC
USB-DM
USB-DP
USB-GND
78
68
Red
White
Green
Black
Shield
ADL2
USB B Type
Socket
50mm (2in) Max Must be USB certified cable
It is recommended that the USB
wires are reterminated to 22#
Tefzel to avoid wire breakage
Maximum length 5m (16ft) including the cable to the PC
Note: When inserting the pins into the Autosport connector check that all the
pins are latched correctly by pulling on each wire – it is very easy for a pin not
to latch correctly which will give an intermittent connection.