MoTeC ADL2 EDL2 - Manual (Page 28)

26 Installation
Display Care
Take care when cleaning the display, use a soft cloth to avoid scratching the
display and avoid aggressive solvents.
Wiring
Pin Connection Details
The ADL2 pin connection list appears at the back of this manual.
Wire
Use 22# Tefzel wire (Mil Spec M22759/16-22) (5 amps max at 100 °C)
Note that the Tefzel wire is difficult to strip unless the correct stripping tool is
used. Be careful not to nick the wires as this may result in wire failure or poor
crimping.
Some sensor connectors may not be available with 22# terminals, in which
case doubling the wire over gives the equivalent of an 18# wire, which is
suitable for many of the common sensor terminals.
For full wire specifications see Appendix P: Wire Specifications.
Connector
The ADL2 uses a 79 pin Auto Sport connector, see Appendix N: Connector
for full details.
To ensure that the connector is sealed plug unused holes with filler plugs. A
heat shrink boot may also be used if desired.
Crimping
Ensure that the correct crimping tool is used for all contacts to ensure a
reliable connection.
The correct mil spec crimping tool must be used for the ADL2 crimp pins. See
Appendix N: Connector for details.
• Note that the Crimp Contacts are type 22D which is needed to set the
crimp tool correctly.