MoTeC ADL2 EDL2 - Manual (Page 42)

40 Dash Manager Software
Predefining these properties makes the channels easy to use throughout the
rest of the software, for example knowing the measurement type allows the
channels to be displayed in any units suitable for that type, with automatic
conversion between the units. For example all temperature channels can be
displayed in Celsius, Fahrenheit or Kelvin.
Channel Names & Abbreviations
The channels names may be changed if necessary. However name changes
should be limited to name preferences rather than redefining the purpose of
the channel, except for the general purpose channels which may be renamed
to suit the current use.
Channel Units
The units for a channel can be selected from a predefined list, for example
the Engine Temperature channel may have units of Celsius, Fahrenheit or
Kelvin. Conversion between units is automatically handled by the software.
Note that the units are used for display purposes only. This means that the
units can be changed at any time with out affecting the calibration of the
channel.
Channel Resolution
The resolution of all channels is fixed, for example the resolution of the
Engine Temperature channel is fixed at 0.1
°C.
Fixed channel resolutions ensure that the unit conversion system works
properly and that channel comparisons can be performed correctly.
Selecting Channels
There are two methods of selecting channels, either the Category Method or
the Search Method.
Category Method
This method divides all the channels into categories and sub categories, so
that the list can be narrowed down to a small list of channels. For example,
the ‘Engine Sensors / Cooling’ category shows a list of channels associated
with the cooling system of the engine.
When selecting a channel from the complete list of channels, it is usually
easiest to use the category selection method, for example when assigning a
channel to an input pin.