B&K Precision 9130 - Manual - Manual (Page 45)

45
Voltage Sweep
Before this operation, please select the channel you need： .
Enter parameters StartValue, StopValue, voltageStep and Delay. Press “View Scan Panel”, then “Run” to sweep
from the Start to the Stop value once or “Step” to manually execute each test step.
Refer to the on line help for more details
6.5.2 Program
Write a simple sequence of test steps using this tool.
Before programming, please select the channel: .
Right-click in the Program area. The program tools (AppendLine, Insert Line, DeleteLine) will appear. Use
these tools to define each test step and add new test steps.
Click on “View Test Control Panel” to execute your test sequence. Select “Run” to execute the sequence in a
loop, “Once” or Custom (define the number of loops)
For more details, refer to the on-line help.
6.5.2 Go/NG
This tool allows you to write a simple test sequence including min/max values. The test program generates a
pass fail verdict and an optional test report.
Before test, please select the channel: .
Right-click in the Program area. The program tools (AppendLine, Insert Line, DeleteLine) will appear. Use
these tools to define each test step and add new test steps.
Click on “View Test Control Panel” to execute your test sequence. Select “Run” to execute the sequence in a
loop, “Once” or Custom (define the number of loops)
For more details, refer to the on-line help.