B&K Precision 9130 - Manual - Manual (Page 17)

17
Power SN display the serial number
Soft Version Display the firmware version
Cal Information
Error Information
Exit
Exit Menu
4.5 Panel Operation
Channel Operation
When the power supply is in “METER” mode, you can select a channel using the arrow keys .
OUT ON/OFF
Pressing
On/Off
toggles the output state of all 3 channels of the power supply. If the output state is ON,
press it, to turn the output state to OFF. While the output state is OFF, press
On/Off
and the power supply
output will turn ON.
To control channels individually, press one of the number keys 1 ,
2 3 corresponding to each channel.
Key 1 controls the output state of the first channel, key
2
controls the output state of the second channel
and key
3
controls the output state of the third channel.
When the power supply is in remote mode, you can set the output state by sending SCPI command（ OUTPut:
ON | OFF
～ The Output state operation doesn’t affect any other parameter.
Note: The
On/Off
key controls the output state of all 3 channels simultaneously.
If you want to control the output state of individual channels, use the number keys 1-3.
Timer Operation
If you have set the output timer and the power supply is in “METER” mode, you can check the remaining time
by pressing 0 . When the timer expires, the power supply will turn off the channel automatically.
Set Voltage
Solution 1: Press
V-set V-set
, enter a numeric value (via key pad) then press
Enter
to confirm.