B&K Precision 9130 - Manual - Manual (Page 20)

20
Baud Rate Set
This parameter configures the baud rate for serial communication. Possible values are 4800，9600，19200 or
38400. When operating the power supply in remote mode, make sure that you configure identical baud rate
settings for the power supply and the computer. The default setting is 9600.
Communication Parity
This parameter sets the parity bit for serial communication. Possible values are NONE, ODD and EVEN.
Default setting is NONE.
System Wait Time
This parameter determines how long the power supply will remain in set mode until it automatically reverts
back to meter mode or output mode The minimum is 4 seconds, and the maximum is 9999 seconds. Enter a
numerical value followed by
Enter
or press +
Enter
to set the wait-time. To disable the system
wait time function, set the wait time to 0 seconds. (In this case, the power supply will remain in set mode until
the ESC or ENTER key is pressed). Set mode is active when a cursor is visible. Default setting is 0 seconds.
Note: the wait-time range is 4~9999S, if you set it with 1~3S, the wait-time will be 4S automatically.
Local Address
With this parameter, it is possible to address each instrument. The address range is 0 to 30.
Key Lock Set
A password can be assigned (1 - 4 digits) to lock the function key operation. After setting the password, there
is a sign displayed on the VFD and all the function keys on the front panel will be locked except of the
On/Off
key (if the knob is enabled, keys can also can be used). You must enter the correct password to
unlock the keys. If you don’t want to lock the function keys, please set the password to 0 when entering
the >SET KEYLOCK function.
When the knob function is enabled:
You can press the keys to move the cursor position, then enter a number and press
Enter
to set
the password. Or press to select the cursor position and change the value using the password using the
knob. Press +
Esc
or
Enter
to exit.
When the knob function is disabled:
Press number key+
Enter
to set the password or use the keys.
• System Set