Load – B&K Precision 9130 - Manual User Manual

Page 22

Connection diagram example: Channels 1 and 2 connected in parallel

Note: When configuring for series or parallel operation, the user must wire

the terminals to match the configuration. The power supply does not

automatically connect the appropriate terminals internally based on the

configuration selected.

MaxVolt Set (LVP)

The max voltage you set should be within the range of 0V to the maximum rated voltage. You can edit this

value using the

keys or via numerical key pad followed by

Enter

. The default setting is the

maximum rated voltage for each channel.

Out Time Set

This parameter sets the output timer for each channel. The range is 1~999999 seconds. If you enable this

function, and the output state of all channels is on, the timer will start counting down immediately. Once the

timer expires (count down from set value to zero) the output of the assigned channel will turn off. To disable

the timer, set the output time to zero.( 0 seconds). Default setting is 0 Seconds.

Load