Atec Tektronix-DPO7000 Series - Manual (Page 9)

Digital Phosphor Oscilloscopes — DPO7000 Series
CAN and LIN Timing and Protocol Decode
Power Measurement and Analysis
CAN and LIN Timing and Protocol Decode Software (Opt. LSA) – When you
need to ensure seamless and reliable operation of a CAN or LIN network,
this option enables CAN bus triggering and provides the solution to measure
oscillator tolerance, propagation delay, and simultaneously decode CAN
and LIN messages, with the protocol leveraging the trigger capabilities.
The optional ATM-1 module adds LIN and advanced CAN triggering.
Power Measurement and Analysis (Opt. PWR) – Analyze power dissipation
in power supply switching devices and magnetic components, and
generate detailed reports in customizable formats. The Hi-Res acquisition
mode delivers greater than 8 bits of vertical resolution on single-shot or
repetitive signals at bandwidth up to 125 MHz. The powerful and flexible
measurements, math, and math-on-math capabilities make it an ideal
solution for performing power measurements, such as voltage, current,
instantaneous power, and energy, for power device designers. The
TekVPI™ interface provides smart communication between the oscilloscope
and the probe. TekVPI probe interface also provides more power to the
probe interface, allowing direct connection of current probes to the front of
the oscilloscope.
Ethernet Compliance Testing
USB Compliance Testing
Ethernet Compliance Testing (Opt. ET3) – Receive full physical layer
support for Ethernet variants 10BASE-T, 100BASE-TX, and 1000BASE-T
with the comprehensive, integrated Tektronix Ethernet tool set. Analog
verification, automated compliance software, and device characterization
solutions are all included.
USB Compliance Testing (Opt. USB) – Provides compliance testing for
USB 2.0 signals. A DPO7254 or DPO7354 is required for compliance
testing of high-speed (480 Mb/s) USB signals.
www.tektronix.com 9