Data sheet – Atec Tektronix-DPO7000 Series User Manual

Page 10

Data Sheet

DDR Memory Bus Analysis

Optional MIPI

D-PHY Characterization and Compliance Testing

DDR Memory Bus Analysis (Opt. DDRA) –

Automatically identify DDR1,

LP-DDR1 DDR2, DDR3, and GDDR3 Reads and Writes and make JEDEC
conformance measurements with pass/fail results on all edges in every
Read and Write burst. DDRA also provides capabilities for measurements
of clock, address, and control signals. In addition to enabling conformance
testing, DDRA with DPOJET is the fastest way to debug complex memory
signaling issues.

UWB WiMedia Analysis and Measurements

MIPI

D-PHY Characterization and Compliance Testing (Opt. D-PHY) –

Verify to the D-PHY specification, rapidly characterize and discover sources
of jitter and signal integrity concerns. Perform high-speed data-clock timing
measurements, along with other electrical characteristics in high-speed or
low-power modes. This option is available on the DPO7254 and DPO7354
models.

Ultra-Wideband Spectral Analysis (Opt. UWB) and Ultra-Wideband
Spectral Analysis Essentials (Opt. UWBE) –

UWBE: Ultra-Wideband

microwave, optical, and electrical signals require more real-time bandwidth
than is possible with spectrum analyzer based solutions. Spectral
Analysis and Digital Down Conversion of RF data is fast and easy and the
down-converted frequency span of interest may be exported for further
analysis in tools such as RSAVu and MATLAB.
UWB goes beyond the Essentials version and adds: WiMedia PHY
1.2 analysis with automatic packet, TFC, and data rate detection,
support for all band groups, and Time Frequency Codes and data rates.
Rapid visualization, debug, and report generation of the Spectrograms,
Power Spectral Density, QPSK/DCM Constellations, EVM-vs-Symbol,
EVM-vs-Subcarrier, Common-Phase-Error-vs-Symbol, and Voltage-vs-Time
plots and complete measurements are captured and documented for each
test condition.